Circuit Board Holder - TI-LaunchXL-F280049C
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
[Update March 26, 2020 - see note below] This was made for my build of the [clough42] Electronic Lead Screw project.
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 117
- Wydruki
- 1
- Wyświetlenia
- 822
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Public Domain
[Update March 26, 2020 - see note below]
This was made for my build of the [clough42] Electronic Lead Screw project. Use with #4 x 3/8 sheet metal screws (#4 ~= 3mm). This is a simple frame to hold the TI-LaunchXL-F280049C for use on the workbench and mounting in the project box.
Note: When I connected a USB cable to the circuit board on my build, I noticed its was very close to the holder. I expect that the USB connector is long enough that this will not be a problem, but just to be on the safe side I made a revision (ti-board-mount3) with a cutout for the USB connector, and add the files for that revision here.
See the Electronic Lead Screw project here: https://github.com/clough42/electronic-leadscrew/wiki
See also these related prints:
https://www.prusaprinters.org/prints/24616-project-box-ledkey-pc-board-electronic-lead-screw
My build is here:
The OnShape 3D CAD file can be found here.
Print instructions
Print with 5 perimeters minimum and zero fill.