Ball Head for camera tripod
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
V1 was promising, but was just an attempt.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 5
- Wydruki
- 0
- Wyświetlenia
- 40
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Share Alike
V1 was promising, but was just an attempt. V2 takes the same ideas, but makes it a single piece, rather than a bolt together pair. I re-did it in OpenSCAD to make it parametric as well.
I am trying to create a ball head mount for a camera. The ball will be a 'hardwood doll head' I picked up at Micheals (42mm or 1 5/8"). This first run has at least one flaw: I didn't build anything into the base to attach it to the tripod because the split is on the centerline.
Print instructions
Category: Camera Instructions
Print, with support. You are going to need to cut out some of the support, so keep it sparse. I think a hacksaw blade may be a good choice to clear out the gap that is supposed to let it be flexible.