Worx landroid cutting height adjuster

My worx landroid (WR143E) had an accident with some rocks which caused the cutting disc to explode and the height adjuster broke. Took the landroid apart and found the broken pieces, glued it back together to have a base to measure from.

Printed in PETG, just secure many walls at the two outwards regions, the screws for attaching the handle is M4 x 12mm.

To disassemble the mover follow the following instructions: Flip the lawn mower upside down, then all screws visible from the bottom must be removed, and all parts connected to the motor must be removed (disc, disc connector to motor and knifes). Afterwards I believe the orange top part must be removed by angling towards the charger connectors, note the orange lid is snap on connected besides the screws and needs detachment multiple places before it can completely release. Side note multiple electronics are connected between top and bottom part so release slowly to avoid damaging the connectors. After the orange top is removed I believe the rest is quite straightforward. Reassemble in reverse order, let me know if further info is needed, I could consider making a guide with pictures if necessary.

Let me know if you need any additional instructions in how to dismantle the landroid unit for this maintenance.

The original spare part may be found here: letmerepair.se → https://reservdelarochtillbehor.se/fritid-tradgard/worx-robot/ovrigt/height-adjustment-knob-50036861
Being approximately 62.5 EUR a pcs.

Feel free to support me @ https://buymeacoffee.com/swagga5aur