1 / 5
Lumina Daphine Terra Floor Lamp Repair — zdjęcie 1
1 / 5

Lumina Daphine Terra Floor Lamp Repair

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A repair for Daphine floor lamp

Ocena
5 / 5
Polubienia
3
Pobrania
92
Wydruki
1
Wyświetlenia
971
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Home Decor
Licencja
GNU General Public License v2.0

This is a repair piece for the plastic bit that covers the electronics of a Lumina Daphine Terra lamp. This is a high stress plastic that controls the stiffness of the lamp arm as the ball joint is forced into it causing friction and the lamp to remain in place. This printed part distributes the stress better across the whole piece.

This looks 99% like the original piece, difference is the original is embossed and the model here is debossed. Print face down on textured sheet for most accurate repro. In the printed example image the debossed logo is very shallow, this is updated in the most recent model here and will print deeper.

Mine was broken and I imagine others will break too if you have this lamp. It seems to be a common failure point.

To get this assembled in the lamp, you have to cut the old one off, including drilling out the rivets. You'll need to replace the rivets with four m3x10mm screws, the heads of which should be large enough to not pass through the drilled out rivet holes, or use a washer. And backed by m3 nuts, I used hex nuts which might rotate in place so you can apply a dab of glue to prevent that, however it's not important since you install this with the body open and just need to tighten enough to clamp the piece on. 

Screw in the main piece to the metal body of the lamp. The words Lumina should be up and legible, this is important for the tall tab (image marked green) in the rear. Thread all the cables and lamp arm through the cutout of the main piece. Place each printed internal half (image marked blue and red) in the main piece and around the ball joint, this now blocks the ball from passing through. Now put the metal hardware on the back. One side sits higher than the other because of the tall tab on the main piece (image marked green), acts like a pivot point.  Then lightly screw the hardware onto the main piece causing the metal bracket in contact with the ball joint to apply some force. Install the rest then adjust the force using the front 2 screws until it moves freely and stays in place but not too tight.  Check the reference photos for what it should look like.

 

I printed in PETG 100% infill for its tacky properties when force is applied. I think PLA would work too. You'll need to print with supports, logo side face down. The supported face will be hidden in the final install.

 

**My lamp is an original from the 70's--they may have changed the design since then and therefore this may or may not fit more modern lamps. If you have a Daphine with the wire bridge near the lamp head, you have an old one I suspect this will work for you

Tagi