Small shell for stock hotend after converting to bowden extruder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
One of the easiest changes to the 101hero is to convert the direct extruder to a Bowden extruder. In doing that, you…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 6
- Wydruki
- 0
- Wyświetlenia
- 120
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
One of the easiest changes to the 101hero is to convert the direct extruder to a Bowden extruder. In doing that, you end up left with a large extruder shell that is more than half empty. This thing contains just the hotend portion of the extruder assembly and allows you to reduce more weight from the print assembly allowing for more stable operation and higher print speeds.
Print Settings
Printer:
101Hero
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.18mm
Infill:
20%
Notes:
To make the installation of the hot end easier, it is important to print the shell in the orientation supplied to have the inside of the shell as clean as possible.
Once complete, remove filament from 101hero and allow the printer to cool down.
Unplug the printer power and computer connections
Remove the extruder assembly and disassemble.
Position the hot end in the new shell aligning the wires into the channel on the side and the PTFE tubing out the notch in the top.
Reusing 3 of the 5 screws from the original extruder, screw the two halves together tightly and move the fan from the old extruder to the new hotend (Note: Make sure you cleaned the vents out on both halves so air from the fan can flow across the heatsink.
Custom Section
Category: 3D Printer Extruders