Sy's Peglock - Gridfinity 3x1 Baseplate
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A baseplate to connect Voidstar Gridfinity containers to my 1" locking pegboard system.
- Ocena
- 4,917 / 5
- Polubienia
- 142
- Pobrania
- 1012
- Wydruki
- 11
- Wyświetlenia
- 5336
- Oceny
- 12
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
Mounting for Voidstar Labs' Gridfinity containers on pegboards without wiggle? Heck yeah!
This model uses my locking pegboard mount system for 1" standard pegboards. Magnet holes (if present) are designed for 10mm diameter, 3mm thick magnets. “Board Attachment” parts are universal to all models. Print with 3 perimeters and 0.3mm or thinner layer height for best results.
To mount, fold the "Board Attachment" model, insert it into the pegboard so the triangular surface points up, then slide the mount over top. With a bit of force it should fully lock into place. If needed, use a small mallet or similar to mount/remove.
Remixed from https://thangs.com/designer/ZackFreedman/3d-model/Gridfinity%20Baseplates-60925