1 / 6
Unifi G3 instant corner mount (90° and 75° downwards) with hidden power cable — zdjęcie 1
1 / 6

Unifi G3 instant corner mount (90° and 75° downwards) with hidden power cable

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Unifi G3 instant corner mount that allows hiding the power cable. Available in 90° en 75° downward angles.

Ocena
5 / 5
Polubienia
34
Pobrania
291
Wydruki
3
Wyświetlenia
1408
Oceny
3

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

I was looking for a decent G3 instant corner mount that allowed me to hide the power cable. I really liked the design of Tadufeu but it lacked the feature to hide my cables so I created a remix for this purpose.

Don't mind the finish off the print (or state of my wall) in the pictures. Both still needed a touch-up, but I ran out of paint :) I've printed in recycled PLA and painted the piece without sanding it since you can't see it from the ground.

The current design allows for the power cable to enter the housing from the right or left. There is also a cover plate to hide everything when it's all in place.

Since I could not rotate the camera low enough with the 90° mount, I created a second design with an 15° downwards angle . Now it's possible to point it low enough to track all of my floors and pets.

Print settings

Used material : PLA
Nozzle diameter : 0.4mm
Layer height : 0.15mm
In-fill: 15% gyroid
Print the pieces (except cover plate) up-side-down for the best result. The 75° mount requires supports for the protruding base plate part.

Extra material

  • Original wall mounting bracket
  • 1 or 2 x 4mm x 40mm+ screws for mounting it to the wall (I used just 1)
  • 2 x 3mm screws (like the included screws from Ubiquiti) for mounting the base plate .

Tagi