Anycubic i3 Mega Mounting Bracket for Articulating Raspberry Pi Camera Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An easy way to attach the "Articulating Raspberry Pi Camera Mount" to the frame of an Anycubic i3 Mega.
- Ocena
- 5 / 5
- Polubienia
- 15
- Pobrania
- 60
- Wydruki
- 1
- Wyświetlenia
- 624
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Anycubic Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Share Alike
An easy way to attach the "Articulating Raspberry Pi Camera Mount" to the frame of an Anycubic i3 Mega. It can be attached and removed without any tools. There is also a slot where you can slide through a cable tie in order to route any cables.
Mounting Instructions
Hook the longer side of the bracket into the printer frame. Then gently press the shorter side of the bracket against the frame until it snaps in place. It should stay firmly, although it might still be able to slide up and down along the frame.
Printing Instructions
I printed it in PLA+ with 0.2 mm layer height, 2 perimeters, and 18 % infill. Regular PLA should work too. No support is required. Depending on filament material and printer, a raft might help to prevent warping and mitigate bad bed adhesion.