Fennec

Parts List:
5015 Fan * 2
4040 10 fan
M4 nuts * 2
M4 bolts * 2 max length 20mm min 10mm
M3 bolts (from stock machine) * 6: Two for mounting onto x carriage, 4 for mounting the fan Max is 12 mm in length
Optional
BL touch, plus mounting hardware
 

Printing tips:

Supports: required

For the fan ducts, use the flat face on the top of the duct so that the duct stands vertically, other orientations can work, but it is more consistent this way

Build guide

Remove everything from the x carriage, and mount the back plate

Install the hotend, and place the two m4 nuts into the little slots on the upper arms

start to screw in the M4 nuts into the holes on the top arm. 

Take the two fan ducts and place the slots around the head of the m4 bolts

For Bl touch: 

Take the cover plate and mount the Bl touch to the two holes make sure the connector for the bl touch is facing away from the hole in the center of the cover plate

X offset: 45.65

y offset: 5.67

Your z offset is going to vary greatly depend on whether you are using the stock hot end, the dragonfly hot end and your nozzle choice, a recommended starting place is going to -4.5

Take the 40 mm fan and 4 m3 bolts and thread it through the cover plate.

Line the m3 blots with the 4 holes on the back plate and screw until tight

You Can now adjust the fan duct height using the m4 bolts

Have fun Printing