Ferret collapsing staff
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Inspired by The Owl House this is a Ferret themed collapsing staff
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 160
- Wydruki
- 0
- Wyświetlenia
- 1125
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution
This is an owl house inspired Ferret collapsing staff. I have included both a print in place version much like the old collapsing light sabers and a version that uses a 7/8 inch dowel. The print in place version is about 88cm when fully extended.
Print Settings
Layer height and infill at your discretion, I use 0.3mm layer height and 7% infill
Make sure your line width in cura is set to 0.5mm and extrusion width is set to 0.5mm in prusa slicer for perimeters
Support aren't necessary but will improve the look under the chin.
I printed this on a MK3S+ at 0.3mm layer height no supports.
For the Dowel version I recommend fuzzy skin on outside walls only