1 / 1
QIDI I-Mate (S) - Improved X-Gantry With Tensioners — zdjęcie 1

QIDI I-Mate (S) - Improved X-Gantry With Tensioners

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a remix of my Improved X-Gantry With Tensioner for printers with 8 mm rods on both X and Y, commonly used by the

Ocena
5 / 5
Polubienia
20
Pobrania
133
Wydruki
4
Wyświetlenia
1514
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Update January 15, 2023

Version 1.3 with perfect alignment of the belts together with Icarus 2. 10 mm rod version pictured below but the same principle. Please take notice of the pulley orientation, see the pictures (new orientation with version 1.3 on the motor side):

The side with the motor, the pulley should sit as close to the motor as possible without rubbing so just 0.2 mm from it or so. 

About

This is a remix of my Improved X-Gantry With Tensioner for QIDI printers with 8 mm rods on both X and Y, commonly used by the QIDI I-Mate and I-Mate S, some of those printers use 10 mm rods though or a mix of 8 and 10 mm so make sure you measure yours first. 

This is for the printed files only, view this for instructions:

https://www.printables.com/model/134871-qidi-x-max-improved-x-gantry-with-tensioners

There are two different versions: One for 17 mm long bearings (LM8SUU, original Qidi bearings) and one for 24 mm long bearings (LM8UU), common for aftermarket bearings such as Misumi. 

My printer is using 10 mm rods so I've been unable to test this but it should work.

Support

All my designs and mods on Printables are free to use and remix. They have a non-commercial license. If you enjoy this or any of my other designs you can send me a small donation using the link below. Thanks :)

https://www.paypal.me/humebeamengineering