NeoPixel ring and toggle switch panel
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This panel holds a 24 NeoPixel ring and a large toggle switch with safety cover. These serve as a status indicator and…
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 340
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
This panel holds a 24 NeoPixel ring and a large toggle switch with safety cover. These serve as a status indicator and printer power switch / emergency stop on my printer enclosure.
Wire it up how you like. I'm using a 74HCT08 as a level shifter for the NeoPixels. The switch interrupts the control signal for the printer's power relay. That way Octoprint can control power, but only if the switch is on.
The panel includes countersunk holes for M3 socket head screws, which attach to right-angle brackets (using nuts). A printable bracket is included. The large hole on the bracket is sized for a #8 wood screw.
Print Settings
Printer:
Prusa MINI+
Rafts:
No
Supports:
Yes
Resolution:
400
Infill:
25
Filament:
Overture PETG
Black
Notes:
Printed with 0.8 mm nozzle. I enabled ironing for the top surface of the panel. Supports are needed only for the back side of the switch hole. Alternately you could place a one-layer bridge over that hole and drill it out after printing.
I used a smaller layer height of 0.3 mm on the brackets, for nicer horizontal holes.Category: 3D Printer Accessories