Mason jar lid peristaltic pump mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
UPDATE 2021-04-30: Added a simple cap to cover the motor terminals. This is a wide mouth Mason jar lid with mounting…
- Ocena
- 0 / 5
- Polubienia
- 22
- Pobrania
- 34
- Wydruki
- 0
- Wyświetlenia
- 870
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- GNU General Public License v2.0
UPDATE 2021-04-30: Added a simple cap to cover the motor terminals.
This is a wide mouth Mason jar lid with mounting holes for a cheap 12V peristaltic pump. I will use this as part of an automated container garden.
The pump I used is https://www.amazon.com/gp/product/B075VN1QZM/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1
The pump attaches with M3x12 screws and M3 nuts and washers. The output tube comes out through a rubber ring designed for a nominal 5/16" hole (sorry to mix metric and American units, but it's what I had on hand). Or skip the rubber ring and it will double as a vent hole (personally I did not find this necessary).
Lid is a remix of https://www.thingiverse.com/thing:19105
I had some problems with the original wide mouth jar lid STL so I re-rendered it in OpenSCAD and have included that as well.
Print Settings
Printer:
Prusa MINI+
Rafts:
No
Supports:
No
Resolution:
150
Infill:
100
Filament:
Overture PETG
Black
Notes:
Be careful that you get good layer adhesion. My initial prototype (in PLA) cracked when I screwed it on, I think because my printing temperature was too low and the layers didn't adhere well. You might want to avoid screwing it on tight regardless. Infill percentage probably doesn't matter; even with only 2 perimeters there is almost no patterned infill.
Category: Outdoor & Garden