1 / 6
USB DC Power Blocker — zdjęcie 1
1 / 6

USB DC Power Blocker

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Simple DC blocker to prevent an Octopi from powering a printer's control board when connected via USB.

Ocena
5 / 5
Polubienia
31
Pobrania
101
Wydruki
2
Wyświetlenia
1842
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Share Alike

Some printer control boards receive power via USB when connected to a PC or OctoPi, which forces the printer's control board to stay powered on even after the printer has been turned off. This is a nuisance when you want to turn everything off (hard reset, firmware update, etc.), so a DC blocker is handy to have. 

This model is a 2-part case that holds standard PC-mount (printed circuitboard mount) USB A connectors (male and female). The 5V DC pin is removed on both connectors and the other pins are soldered straight through. 

Tips on Assembly:

Parts:

  • use standard PC mount USB male and female connector parts
  • print one complete set (body and lid) for each USB DC Blocker you intend to make

Preparation:

  • plug/join the male and female connectors together at this point
    • makes removing the correct pin easy to track
    • see the USB pinout to identify the 5V pin
  • remove/pull the 5V DC pin from both the male and female connectors
  • bend the PC mount tabs flat (see pictures)
  • carefully bend the remaining pins out flat (see assembly pictures)
  • put the unsoldered connectors into the body
    • dry-fit the lid to set the spacing before soldering
    • bend the pins as required to make soldering easier
      • i.e. they should be touching and aligned with each other

Soldering:

  • place a small dab of solder flux on each pair of pins (optional, but recommended)
  • use as little solder as will do the job
    • don't bridge solder between the pins
  • after soldering the top, remove the assembly from the body 
    • lightly solder the bottom of the pins
    • make sure you have good solder flow all around
    • allow each pin to cool fully before flowing the next one
      • otherwise the spacing/shape will be lost

Testing (before final assembly):

  • connect DC blocker into OctoPi, plug USB cable into DC blocker and connect to printer
    • printer→USB Cable→DC Blocker→OctoPi
  • make sure you can still connect to the serial port
    • perform homing operations, etc
  • If trouble, check with multimeter/continuity beeper
    • make sure all 3 signals are connected between USB connectors
    • make sure there are no shorts between pins
  • Test that powering off printer also powers off the board

Final Assembly:

  • Place the soldered connector assembly back in the housing body
  • carefully put a dab of hot melt glue into/onto the middle of the connector assembly
    • careful not to use too much
    • use work gloves (cotton or leather) to avoid nasty burns from the hot melt
  • quickly push the lid into place and hold tightly until hot melt hardens
    • make sure  the tabs go into the right recesses on the connectors

 

Re-test. If it still works, you're done.

 

 

Tagi