Voron V0.1 Phaetus Rapido Mini Afterburner Multibody
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is simply a stretched multibody to move the part fan ducts down closer to the Rapido's nozzle. No other changes.
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 67
- Wydruki
- 1
- Wyświetlenia
- 1692
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Voron Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I do not recommend that you use a Rapido. It's a great hotend and has performed well, but it's just better to stay in the developed ecosystem and save yourself the headaches of a custom job. I like what I have but I wouldn't do it again.
When I upgraded my Voron V0, of course bought a hotend that was not supported. While it could be mounted in the stock multibody the nozzle stuck out the bottom by about one centimeter. This meant that the part fans were worse than useless as they were blowing on the heater block. Silicone sock or not, that just didn't work.
I simply took the existing multibody and stretched it to bring the part fan ducts to be by the nozzle. I reused all the components I used previously on my E3d V6 hotend (I think. It's been a while).
You will have to go into your firmware and adjust various parameters to properly locate the nozzle and define the print area. I can't remember what the parameters I changed were or what I changed them too. I do remember that it was a pain though.
Seriously, pick one of the supported configurations instead. Save yourself some pain.