Case for Doogee S88 Pro
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Portable Devices
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Update 19.11.2023:
Added STEP files of top and bottom part.
Case for Doogee S88 pro
As described here roughly a year ago, I switched to using a smartphone for motorbike navigation (and didn't regret that decision). So far, I've been using a Doogee S60 which is good for about 9-10 hours of riding in bright sunlight before the battery goes flat. Which is ok, but when the S88 pro with it's even bigger battery came out, I went for it and so I needed a new case to mount it on the bike.
This design works like the last one, there's a bottom and a top part that are held together by reusable cable ties. The case has a RAM mount (RAM-B-347U) bolted to the back. I also made a part that you can insert between the RAM mount and the bottom part, but that's strictly optional.
Printing
I used PETG (Innofil3D pet-0307) again to print it as the previous case still seems to be fine after one year of exposure to UV light. Printing should be easy (no supports needed), though PETG has a tendency for stringing. Printing was done using 25% infill for the top and bottom part and 100% infill for the mounting part.
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK2 MMU
Rafts:
No
Supports:
No
Resolution:
0.2
Infill:
25%
Filament: Innofil3D PETG Green
Category: Mobile Phone