Sy's Peglock - Tape Measure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A tape-measure sized rectangular dish for my 1" locking pegboard system.
- Ocena
- 5 / 5
- Polubienia
- 66
- Pobrania
- 808
- Wydruki
- 8
- Wyświetlenia
- 2787
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Share Alike
This tape measure holder (or shallow dish if you prefer to use it for something else) prints without supports (make sure your bridging settings are dialed in!). Uses two board attachments.
This model uses my locking pegboard mount system for 1" standard pegboards. Magnet holes (if present) are designed for 10mm diameter, 3mm thick magnets. “Board Attachment” parts are universal to all models. Print with 3 perimeters and 0.3mm or thinner layer height for best results.
To mount, fold the "Board Attachment" model, insert it into the pegboard so the triangular surface points up, then slide the mount over top. With a bit of force it should fully lock into place. If needed, use a small mallet or similar to mount/remove.