Curvy 6 Pack Carrier - 16oz Cans
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A few people expressed interest in a version of my 6 Pack Carrier for 16oz cans so I resized it for the few people…
- Ocena
- 5 / 5
- Polubienia
- 6
- Pobrania
- 80
- Wydruki
- 1
- Wyświetlenia
- 718
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution
A few people expressed interest in a version of my 6 Pack Carrier for 16oz cans so I resized it for the few people interested.
This carrier holds 6 16oz cans. The handle and anchors are screwed together using 2 M5 screws (10mm to 25mm, any size between will work). Two pairs of 6x3mm magnets hold the top and bottom half together. It is a tight tolerance (0.5mm) between the can and the walls to prevent them from rattling around in the carrier.
Print instructions
I used the default Prusament PETG settings since I printed it using generic Amazon PETG. The only change I made was I used 4 perimeters. I recommend doing this as well as the walls are deigned to be exactly 1.6mm wide.
The only part that needs support is the handle due to the fillets on it. Be sure to orient all the prints so that there aren't any overhangs to save on support filament.