Ender 6 with top cover, CoreXY Cablechain Rear Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I remixed the rear mount as my Ender-6 has the Top cover and the rear mount blocks it as it sat on the rop rail. I…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 288
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
I remixed the rear mount as my Ender-6 has the Top cover and the rear mount blocks it as it sat on the rop rail. I altered it so it only sits on the top rail by 5mm and clears the top cover. The rear was also modified to make it a little easier to get the cables through it.
I used 100% infill as test prints showed it could break as the chain put a bit of tension on it but at 100% infill it seems fine.
I used tree supports to get a clean print and orientated it upside down, the STL is saved in that orientation.
This rear mount was remixed from https://www.thingiverse.com/thing:4731935
Print Settings
Printer:
Ender-6
Rafts:
No
Supports:
Yes
Resolution:
0.2mm
Infill:
100%
Filament:
Overture PLA
Black
Category: 3D Printer Accessories
