Tower Planter Pot
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Castle tower for your succulent? Yes, another succulent planter for your desk or home.
- Ocena
- 4,975 / 5
- Polubienia
- 588
- Pobrania
- 2619
- Wydruki
- 59
- Wyświetlenia
- 8153
- Oceny
- 40
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Decor
- Licencja
- Creative Commons — Attribution
Castle tower for your succulent? Yes, another succulent planter for your desk or home. This one has the over water drain in the lower level. If you see water there, you have watered too much. The bottom vents allow the soil to breathe.
This was printed using 3D Mars Wood PLA at a resolution of 0.2 and 20% infill. There is no need to use supports when printing. All the over hangs are arched and should print just fine without support.
Overture Matte Light Brown PLA: https://amzn.to/3C9JIxr
Finished with Sedona Red Minwax: https://amzn.to/2mWSszV
With a clear coat of satin clear spray: https://amzn.to/2LFHgXr
You can get the Minwax and Satin Clear spray from a local Home Depot.
Print instructions
Category: Decor Print Settings
Printer: Maker Select
Rafts: No
Supports: No
Resolution: 0.2
Infill: 20%
Notes:
Used 3D Mars Wood PLA and stained it with Min Wax followed by a satin clear coat.