RX5808 Solderless Module Bay for RotorHazard BPill Board
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a RX5808 Solderless Module Bay for RotorHazard BPill Board It is designed as a rig for testing RX5808 VRX…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 206
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a RX5808 Solderless Module Bay for RotorHazard BPill Board
It is designed as a rig for testing RX5808 VRX modules, as used in RotorHazard and Delta5 race timers, as well as RX5808 diversity receivers.
The rig holds little pogo pins in a line, which can provide a solderless connection between an RX5808 module and a PCB, or direct to an MCU (eg Arduino/STM32/EPS32), for testing.
Pogo pings were purchased from: https://www.amazon.co.uk/gp/product/B07FQF2BRC
A sample sketch is included, which writes to the RX5808 frequency register and reads back the result to verify, as well as showing 5 x sampled RSSI readings.
The idea can be reworked for other components and circuit boards, which can be useful for example to test components without soldering them (and voiding a warranty).
Print the model with the holes going vertically (the holes will get squashed printing them horizontally)
Because the pins are so small, I used a first layer height of 0.1mm and a layer height of 0.1mm.
Category: 3D Printer Parts