Cooling Duct Ender-6 Bondtech DDX V3 with Mosquito hotend
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I remixed on the authors models for the 4010 fan for the Ender-6 as the cooling ducts were not central on the mosquito…
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 112
- Wydruki
- 0
- Wyświetlenia
- 1147
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
I remixed one the original models for the 4010 fan for the Ender-6 as the cooling ducts were not central on the mosquito hotend, once duct two ducts were close but the third was offset by quite a way. This one better suits the Ender-6 with a BondTech DDX V3 and a Mosquito hotend but probably other hotends too.
I requires no supports.
it was remixed from https://www.thingiverse.com/thing:4933703
Print Settings
Printer:
Creality Ender-6
Rafts:
No
Supports:
No
Resolution:
0.12
Filament: eSun ABS+ Black
Notes:
It was printed in eSun ABS+ at 240c with a bed temp of 90c with 100% infill. You can use the same nut that comes with the Bondtech kit or use a 2ea M3 nut which is square.
Category: 3D Printer Accessories