UFO Spinning Top
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A UFO spinning top for a 2 Nozzle printer. spins very well and is satisfying to watch.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 29
- Wydruki
- 0
- Wyświetlenia
- 225
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Toys & Games
- Licencja
- Creative Commons — Attribution — Share Alike
DESCRIPTION
This went through many iterations. Some prints failed, some had pieces broke off. But this one, this one passed the shatter test. So spin it off the table onto the floor if you want because it won't shatter if you follow my print settings.
Some assembly required, all you need to do is put a dollop of super glue into the hole under the UFO and then insert the spin part. Wiggle is around a bit and press it down to make sure it goes in straight. Once it dries, it is ready to spin.
Spin it as a visual fidget, or print 2 and make them fight.
PRINT SETTINGS
- Supports everywhere
- Infill: Cubic Subdivision, 25%
- Size: 4.5cm from side to side of the UFO or larger. (print it smaller and you risk breaking).
NOTES
Might try to make one with a base to reduce the mess that the supports leave on the bottom. I could be sanded, heated up and then double as a small base to spin your top inside.
If you make this, please post it so I can see! THANK YOU.