1 / 4
Gotrax GXL v2 electric scooter hidden AirTag holder
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Easy print, no supports. Screws right in under the rear fender. Attach with 20mm M4s
- Ocena
- 5 / 5
- Polubienia
- 10
- Pobrania
- 117
- Wydruki
- 3
- Wyświetlenia
- 1374
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Vehicles
- Licencja
- Creative Commons — Public Domain
SzczegółyPliki (2)Wydruki i komentarze (Wydruki: 3) (Komentarze: 7)Remiksy (0)Kolekcje (20)Powiązane
Simple model, no supports. I think it should hold up fine with any filament.
I printed it at .3 layer height 20% gyroid infill in PETG
I printed the version with the bigger holes. The side with the holes closer to the edge will face the front of the scooter. (It is obvious when installing it.)
I created another version that has an arrow to make it easier. It also has hex shaped holes because I was thinking that might help with adhesion.
Attach with 20mm M4s.