CR-6 SE Hot End Intake
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Air intake for the CR6-SE that pulls colder air from above the hot end (rather than hot air from below).
- Ocena
- 0 / 5
- Polubienia
- 17
- Pobrania
- 60
- Wydruki
- 0
- Wyświetlenia
- 705
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
Inspired by 3Deth's and RICBRU's work, I've designed my own CR-6 SE air intake with two-tone air deflectors.
I'm not sure if this surpresses any noise...it's just designed to look cool while redirecting the vent to pull colder air from above the hot end (rather than hot air from below).
You'll need one intake and three deflectors. The intake prints upside down and doesn't require supports. I printed it with 0.2mm layers and 10% infill.
Magnets
The intake is attached with four 5x3mm magnets (I got mine from Amazon).
Since dimensional accuracy varies from printer to printer, there are three versions of the intake with different-sized sockets for the magnets. Print the Magnet Test file to test-fit your magnets, and choose the corresponding intake.
- I = 5.1mm socket
- II = 5.2mm socket
- III = 5.3mm socket
I used 5.2mm, but the magnets have a tendency to pop out when I remove the air intake. If I printed it again, I'd use the 5.1mm version.
Post-printing
The deflectors press-fit into the intake from the inside. When installed, the very tops of the deflectors should be parallel to the top of the intake (not perpendicular) so that they fit as tightly as possible into the cutouts and leave no gaps.
Press-fit the the magnets into their sockets, and you're good to go.