Rear Cable Cover Sovol SV05
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Covers and hides the cables running up the right-rear 2040 extrusion on the Sovol SV05.
- Ocena
- 4,75 / 5
- Polubienia
- 35
- Pobrania
- 346
- Wydruki
- 7
- Wyświetlenia
- 1572
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
In testing the Sovol SV05, I noticed there was only one small clip securing the cables to the right rear 2040 extrusion. I liked @Knuffelrups Cablecover Ender 5 (plus) 2040 model, but I wanted it to grip the extrusion a little bit better.
So I brought it into Tinkercad and added a bit more of a catch to hold onto the extrusion, made it one millimeter wider, and then added a notch for the bed cable.
I sized it so you could print two of them and snap them on, notched sides together, and they'll cover all the way from the bottom to the top of the printer, with just enough of a gap for the cables to enter and exit.
I printed two of these at the same time, sliced at 0.28mm layer height, in about 5 hours, 30 minutes.