Gap fillers for vase mode interlocking drawers
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Improve the look and stability of the Vase Mode Interlocking Drawers
- Ocena
- 5 / 5
- Polubienia
- 2
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 208
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
I found the vase mode drawer sleeves slide around, and also didn't like the look of the gaps between the drawers, so I created these filler pieces that press in quite tightly and give the interlocked drawers more stability.
These fillers are NOT vase mode, but printed at 0.2mm with about 15%-20% infill
There are 3 variations that I have called half, standard and double. Based on the narrow, standard and wide widths of the sleeves.
UPDATE:
I have added a point to the end of the fillers, so they meet in the middle rather than leaving a little gap. There are single, double and half versions, both with 1 or 2 points (1 point if it's going at the end of a row/column!