2in Sanding Pad / Sanding Disk Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a set of holders for 2" (50mm) Velcro backed sanding pads.
- Ocena
- 0 / 5
- Polubienia
- 19
- Pobrania
- 94
- Wydruki
- 0
- Wyświetlenia
- 448
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
This is a set of holders for 2" Velcro backed sanding pads. I have previously made a set of holders for 5" disks here and from requests, made them for a bunch of grits. I used that info to make these with all of the requested grits right off the bat, so these are available in the following grit labels:
40, 60, 80, 100, 120, 150, 180, 220, 240, 320, 400, 600, 800, 1.0K, 1.2K, 1.5K, 2.0K, 3.0K, and blank.
These have “2 Inch” on the holder. If you want “50mm” on the holder, those are here.
I made them with the corners open on the bottom so I could weight them with sand or lead shot and epoxy, then put some neoprene on the bottom to prevent them from moving around on my bench. I just printed one to try it out, and it looks good, but I may be slightly biased. :-)
There are STL files as well as the SolidWorks files.