PCI Express x4 Riser Cable Retention Clip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I created this clip to hold in the male end of the riser cable sold at https://www.amazon.com/dp/B07Y46WTD1 as well as…
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 634
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
I created this clip to hold in the male end of the riser cable sold at https://www.amazon.com/dp/B07Y46WTD1 as well as other similar listings.
Part is pre-aligned to lie down on build plate, print without supports. Adjust horizontal expansion in Cura if it fits too tight.
The clip should hold in place on the board. When pushing the cable in it should snap into place, and to remove simply lift up on the clip to release it.
FreeCAD model is included alongside the STL.
Print Settings
Printer:
HyperCube
Rafts:
No
Supports:
No
Resolution:
0.2mm
Infill:
25%
Filament:
Eastar 6763 PETG, used Filastruder
Transparent
Category: Computer