Anycubic Chiron Spring-based Damping Feet
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Saw this design on a YouTube channel (https://www.youtube.com/channel/UCkXj9_80x1PquHxWZtT-6Hg check the videos abtout…
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 35
- Wydruki
- 0
- Wyświetlenia
- 353
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
Saw this design on a YouTube channel (https://www.youtube.com/channel/UCkXj9_80x1PquHxWZtT-6Hg check the videos abtout the Chiron - cannot remember the exact one...) a couple of months ago and decided to design the feet myself to get some more practice in Fusion360.
Consists of 4 main parts:
- upper disc
- spring - or - "puffer"
- lower disc
- damper pad underneath (see cross section for details)
Print the "puffer" in TPU (used some quite old FlexiSmart stuff found on Amazon) just in case you do not have a suitable spring on hand. Stiffness of the buffer can be managed by infill percentage - have done mine with 50% and works quite well.
The setup will not entirely stop the Chrion from wobbling around, but shows some good improvements when printing with 60mm/s
Just forgot: you will need 4 of them ;)
Print Settings
Printer Brand:
Monoprice
Printer:
Mini Delta
Rafts:
No
Supports:
Yes
Resolution:
0,2mm
Infill:
50%
Filament: Nothing special... PETG Cheap stuff from Amazon
Notes:
when printing PETG or ABS on the Monoprice Delta Mini make sure you have a proper skirt enabled to keep the print on the bed and to avoid warping. I used 240°C nozzle and 60°C on the bed and it worked quite good. Will take approx. 45min for each disc
Remove the support
the discs will have some support material on the inside since bridging does not work properly at this size - remove with pliers or cutter
Glue the damper pad
Have printed the damper pad in TPU and glued it to the lower disc using some UHU Hart PVC glue - sticks very well and does a good job on a flat surface to avoid the printer moving around (pads were printed on a Flashforge Dreamer for easier TPU handling)
Category: 3D Printer Accessories