Roborock S6/S5 Max Base
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Base for the roborock S6/S5
- Ocena
- 4,5 / 5
- Polubienia
- 42
- Pobrania
- 200
- Wydruki
- 2
- Wyświetlenia
- 1590
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
A remix of a remix of the Roborock Docking Station to fit even smaller printing beds.
The remixed split version was made for CR10 and it did not fit on my Creality Ender 3 S1 bed size of 220mm by 220mm by 270mm, so I made a few adjustments to make it fit diagonally and upright on smaller beds.
Note: Each Q piece did take about 18hrs or so to print.
20% infill was fine, except for the dowel and screen parts, for which I used 100% infill for extra strength.
Printed with PLA.
Add supports for the overhanging dowels only on Q1, Q2 and Q3 pieces. (If enough demand, I might remix it so that all the dowels are printed completely separately from the base pieces, in order to eliminate any need for any supports).
Print Settings
Printer brand: Creality
Printer: Ender 3 S1
Rafts:No
Supports: Yes
Infill: 20%
Filament brand: eSun
Filament color: white
Filament material:PLA
Notes:
Add supports only where you see overhanging dowels.
Post-Printing
Insert the two standalone dowels, and glue the four pieces together. Glue the two mesh pieces together, but leave the mesh removable for easy cleaning.