moyai keycap with keycap bottom
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
moyai keycap. :>
- Ocena
- 4,75 / 5
- Polubienia
- 70
- Pobrania
- 638
- Wydruki
- 4
- Wyświetlenia
- 2476
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Computers
- Licencja
- Creative Commons — Attribution
remix of : https://www.thingiverse.com/thing:4804448
YOU HAVE TO PRINT IT UPSIDE DOWN! (at least i had to)
rotate it 225° in the slicer and use support settings below.
after slicing it should come out like in the picture.
i sliced it in ultimaker cura 5.0.0
these are my settings below. It worked for me but i think it might take you a few tries before it comes out right.
ultimaker cura settings :
QUALITY
resolution: 0.12mm
WALLS
wall thickness 1.2mm
wll line count:3
horizontal expansion: 0.0mm
TOP/BOTTOM
top/bottom thickness 0.84mm
top thickness:0.84mm
top layers: 7
enable ironing: doesnt matter
infill density: 10%
infill pattern: zigzag (probably doesnt matter zigzag is just the fastest)
MATERIAL
printing temperature:210C
build plate adhesion temperature: 60C
SPEED
print speed: 50mm/s
infill speed: 50mm/s
support speed: 25mm/s
intitial layer speed:20mm/s
TRAVEL
enable retraction:yes
combing mode: off
z hop when retracted: yes
COOLING
fan speed: 100%
SUPPORT
generate support: yes
support placement: everywhere
support overhand angle: 60.0
BUILD PLATE ADHESION
build plate adhesion type: Brim