Reinforced PrintNC Nema23 Z Motor mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modified to utilise an LJ12A3-4-Z/BX endstop sensor, and to fit around both sides of the main Z plate, to reduce motor…
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 68
- Wydruki
- 0
- Wyświetlenia
- 738
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Modified to utilise an LJ12A3-4-Z/BX endstop sensor, and to fit around both sides of the main Z plate, to reduce motor wobble. There are also recesses to install M6 nuts, instead of using plastic threads.
Additional holes in the design to allow for efficient printing in solid ABS.
Print Settings
Printer:
MortarBot v2
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
100
Filament:
Esun ABS
Red
Notes:
An enclosure is likely required to print this in ABS. Printing in PETG or PLA should be fine for most builds.
Category: Robotics