Dexcom G4 G5 Night Arm cover - supportless
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I've included a couple of screenshots from Slic3r, in an attempt to demonstrate the most complicated feature to print…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 121
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I've included a couple of screenshots from Slic3r, in an attempt to demonstrate the most complicated feature to print in this model. The cut-away screenshot, shows three parallel lines, designed to be bridged. It may be necessary to run a bridging test,to ensure you can print this part successfully.
The model shown in the photos is the first one made and tested by the individual who requested I print this. It's worked for a few nights, without a compression failure, and is reportedly comfortable. It's held on with a 2cm wide Neoprene strap, designed for sunglasses.
It was printed in ASA, with 3 perimeters, and 20% infill.
After printing, due to steep overhangs, some surface sanding is required, and the bridges need to be cut, to allow the strap to be fitted. I sanded this one quite thoroughly as it's a wearable.
Available on Ebay; https://www.ebay.com.au/itm/323098431968
Category: Gadgets