Bosch GluePen stick holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I like my GluePen but the most annoying thing is that stick keep falling out of its end. I designed a stick holder…
- Ocena
- 5 / 5
- Polubienia
- 7
- Pobrania
- 38
- Wydruki
- 0
- Wyświetlenia
- 421
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
I like my GluePen but the most annoying thing is that stick keep falling out of its end. I designed a stick holder that is fixed with double-sided foam tape over the gun and can also hold 5 reserve sticks.
My sticks are about 7mm in diameter but they're a bit tight, due to my printer being out of tolerance. You can scale it up 1-3% if the sticks are difficult to insert.
Designed in OnShape, I can put up the link if anyone wants to modify it.
EDIT: V2 has bigger holes so the sticks now fit easier, it only takes 4 extra sticks, and fits the glue pen better. I recommend this version instead of the initial one.
Print Settings
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.3
Infill:
20-30%
Filament: any PLA
Category: DIY