Guitar Pick Holder Keychain
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Keep your guitar pick(s) close to you, with this keychain holder.
- Ocena
- 4,5 / 5
- Polubienia
- 133
- Pobrania
- 557
- Wydruki
- 3
- Wyświetlenia
- 2933
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial
Guitar pick holder keychain that allows you to always carry 1 to about 3 picks with you, attached to your keys, bag, or wherever you want. I've tried to keep it a simple design, but efficient. Could be thinner, just for one pick, but I wanted to make sure it was strong enough, and I didn't want to use too small magnets (which add to the thickness)
Both pieces can be printed at the same time, outside face down (stl should sit correctly on the slicer). No support needed.
Printed in PLA, wood PLA, dual tone PLA.
0.15mm layer height.
3 Walls, 20% infill (really up to you).
I've also added initials on the top, and even without dual colors it's still visible if printed upside down.
The container uses:
5x2mm magnets (4) to lock top and bottom,
ring through the hole (2cm and 3cm diameter rings worked well)
clasp attached to the ring, but one can find different solutions.