Sink Strainer 76mm
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Two part sink strainer with 76mm diameter, 15mm hight and little handle. Fits 80mm drains.
- Ocena
- 0 / 5
- Polubienia
- 26
- Pobrania
- 290
- Wydruki
- 0
- Wyświetlenia
- 1131
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Public Domain
I couldn't find any strainer for my kitchen sink so I made one myself. The nominal diameter of the drain is 80mm but it's rather shallow and has quite a big radius at the bottom. That's why this strainer is only 15mm high.
The top part is seperate for easier printing. The diameter is 105mm. It fits quite snuggly with a little bit of force.
I printed it on my Ender 3 v2 with 20% Infill, no support needed in PLA (let's hope it holds up against boiling pasta water).
The inspiration for this design came from surewhynot over at thingiverse.com/thing:2166321