1 / 1
Gridfinity SD Card Holder (Actually Good Edition)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
All the other SD card holders for Gridfinity I could find were not the best. This one is!
- Ocena
- 4,914 / 5
- Polubienia
- 145
- Pobrania
- 1618
- Wydruki
- 40
- Wyświetlenia
- 5455
- Oceny
- 35
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 40) (Komentarze: 43)Remiksy (2)Kolekcje (314)Powiązane
Holds 4 full-size SD cards in a 1x1 Gridfinity square.
Awesomeness:
- Holes are 2CM deep (SD cards are 3CM) so even if you bump it, they won't go flying all over the place
- Holes are offset, creating a 1CM gap for your fat fingers to go either side and pick out a card easily
- Holes are filleted to guide the card in even if you're not really paying attention to what you're doing
- Module has a lip, so you can stack stuff on top of it if it's empty
Why:
Other models I found all required frickin tweezers to get at the card you wanted, and launched the cards all over the room if you even thought about bumping them. This fixes both of those problems!
How 2 print pls halp:
- PLA
- No supports
- Poosh Buttan - Receive SD Holder
- Only works when printed in orange. All other colours will not properly contain the colours of the videos or images on your SD card.