Main Power Restoration Delay / Equipment Saver
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
After an outage, waits for power to stabilize before re-powering equipment.
- Ocena
- 0 / 5
- Polubienia
- 7
- Pobrania
- 12
- Wydruki
- 0
- Wyświetlenia
- 129
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Where we live, power goes out a lot. “Like a-lot a-lot”. The real problem is when it comes back on - or tries to come back on, rapid fire bursts, voltage issues, etc.. After the last outage and the loss of some equipment I had a need and the need turned into a design and the design turned into this…
https://www.instructables.com/member/CBGjr/instructables/
Basically an Arduino Micro Pro, a relay and an LED. When power comes on it waits 30 seconds before turning on the relay. If power flips in the interim, no worries, the counter just resets.
Here are the printed parts for that project.
I used PLA and since this was a test I ran everything at .35 (you might notice some “issues” with the center top arc on the one bracket).
Like my design, how about a cup of coffee?
