1 / 4
Wanhao i3 / Maker Select V2 MKS Gen 1.4 Adapter — zdjęcie 1
1 / 4

Wanhao i3 / Maker Select V2 MKS Gen 1.4 Adapter

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is an adapter to mount the MKS Gen V1.4 board into the original Wanhao Duplicator i3 control box. It also has…

Ocena
0 / 5
Polubienia
0
Pobrania
12
Wydruki
0
Wyświetlenia
183
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

This is an adapter to mount the MKS Gen V1.4 board into the original Wanhao Duplicator i3 control box. It also has mounting points for a MOSFET with 52mmx42mm hole spacing such as the BIQU.

It fits around the existing Melzi standoffs, and can be held down with M3 screws and washers. The board(s) can be secured with M3 screws. The M5 screws on top of the control box will need to be removed or backed off, and I put a piece of electrical tape on the inside just as insurance against a short.

The cable that comes with the BIQU MOSFET was too short to reach the screw terminal on the MKS board, so you will need to fashion a longer one with dupont connectors or a JST if you're feeling fancy.

Category: 3D Printer Parts

Tagi