3D Printer 20x20 Extrusion Knife Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Check out this "sharp" design where 3D printing and cooking hobbies "cross" paths!
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 173
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
I'll get right to the “point”, this is my entry for the Knife Holder Flash Contest! I wanted to design a knife holder that could be used while cooking in the kitchen, but paid homage to our 3D printing passion!
I started with a model of a 20x20 aluminum extrusion so common on many printers as the knife block. I then added a base (with trim band) for balance, but also to catch any oils or drippings from the blades. Although simple, I think it makes a effective tool in the kitchen!
I hope my design was able to “hold” your attention long enough to gather a few votes! Good Luck to all the designers! :)