Double ceiling hook
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I wanted to hang some extension cords from the ceiling of my hall closet, but I didn't like any of the commercial…
- Ocena
- 4,75 / 5
- Polubienia
- 70
- Pobrania
- 372
- Wydruki
- 6
- Wyświetlenia
- 1088
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Share Alike
I wanted to hang some extension cords from the ceiling of my hall closet, but I didn't like any of the commercial offerings or existing 3D designs, most of which seem optimized for hanging plants and stuff. I needed a much larger hook opening, to hold a whole bundle of cord.
This prints sideways, which means it needs a bit of support material for the curves that rest against the bed. Those curves are essential for not cutting into the cord, though.
It has clearance holes to pass a screwdriver, and I secured mine to the ceiling with 3-inch woodscrews through the plaster and straight into a joist. It'svery strong -- I didn't actually try to hang my body weight from it, but I don't hesitate to grab it for stability when I'm climbing around in there.
If I print any more of these, I think I'll add more fillet or webbing where the spine meets the ceiling base. Happy to do that if you'd find it useful; leave a comment!
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
Yes
Resolution:
0.2mm
Infill:
30%
Filament: inland PLA+ any
Notes:
I had good results with lots of shells (4 or 5 I think) and not a ton of infill, 20-30% seems fine.
Category: Organization