1 / 6
Crimp positioner holder for Astro/DMC/Iwiss M22520 indent crimper — zdjęcie 1
1 / 6

Crimp positioner holder for Astro/DMC/Iwiss M22520 indent crimper

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

The IWISS HD-2612D and similar crimpers have a positioner that screws into the back to hold the contact at a specified…

Ocena
0 / 5
Polubienia
2
Pobrania
9
Wydruki
0
Wyświetlenia
354
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Share Alike

The IWISS HD-2612D and similar crimpers have a positioner that screws into the back to hold the contact at a specified depth during the crimp operation. This positioner makes the whole unit too thick to fit in most toolbox drawers.

Removing the positioner means it's easy to lose, however.

So I made a little clippy holder that sticks to the back of the crimper frame. It holds all three positioners, with enough clearance for one to contain the jam-nut, and the whole kaboodle is no taller than the frame by itself.

There's also a little notch to indicate the selected gauge, since the mark on the frame is covered up.

This is a remix of thing:4906409 with the nest spacing adjusted to the jam-nut can live on the middle positioner rather than the uppermost, which further reduces the profile so it fits in my toolbox's thinnest drawer.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3 Pro

Rafts:

No

Supports:

No

Resolution:

0.2mm

Infill:

40%

Filament: inland PLA+ any


Notes:

The geometry should be pretty forgiving of print settings, but if you haven't tuned your printer's horizontal expansion (at least that's what Cura calls it), you might want to do that to get a snug fit.

Category: Hand Tools

Tagi