Artillery Sidewinder x1 - Gantry Support
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Initially I planed to add another support to the front of the printer. I will probably not continue to do so as the…
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 1107
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Initially I planed to add another support to the front of the printer. I will probably not continue to do so as the printer is now stiff enough with only the support to the back.
So I guess the top attachment points can be used to install a camera or some LEDs.
DISCLAIMER: in order to attach the lower attachment points, you have to drill some holes into the enclosure. You do this on your own risk!
Any warranty will probably be voided by this.
Dont forget to unplug the AC-cable before doing so!!!
The benefit of this is, that you can open the bottom enclosure of the printer as easily as before.
Additional hardware :
(no guarantee of correctness or completeness)
2x 10mm aluminium tubes (or something of similar diameter)
8x m5x35mm bolts
4x m5 nuts
26x m3x20mm bolts
2x m3x30mm bolts
4x m3x12mm bolts
8x m3x8mm bolts
28x m3 nuts
12x M3 drop in t-nuts for 6mm slot
4x m4x10mm bolts
4x M4 drop in t-nuts for 6mm slot
some washers
Print Settings
Rafts:
Doesn't Matter
Supports:
No
Category: 3D Printer Accessories