UPDATE: Angled Laptop Stand / Exended Support
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Orientacyjna cena wydruku pliku
5,87 € – 7,17 € netto (bez VAT)
Dla pliku: Laptop Stand_EXT_3Hole_15_PLA_MK2S_6h27m.gcode
To wstępna wycena jednego pliku. Dokładną cenę poznasz przed zamówieniem.
Plik i założenia wyceny
Plik użyty do wyceny
Średnia wycena orientacyjna: 6,52 € netto (środek widełek).
- Masa podana przez autora
- 83 g
- Czas druku podany przez autora
- 6,45 godz.
- Materiał u źródła
- PLA
- Materiał wyceny
- PLA
- Drukarka wyceny
- Bambu Lab P1S - 0.4 nozzle
- Proces wyceny
- 0.20mm Standard
Orientacyjna wycena wyłącznie wybranego pliku, oparta na masie i czasie druku podanych przez autora. Warianty plików nie są sumowane. Ostateczna cena zostanie obliczona po analizie pliku.
Zapisane na tym urządzeniu.
Same laptop stand as before, just with extra surface area to spread out the stress points plus now with more holes!! :-)
- Ocena
- 5 / 5
- Polubienia
- 107
- Pobrania
- 1056
- Wydruki
- 7
- Wyświetlenia
- 4495
- Oceny
- 6
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial
UPDATE: As with my original stand, I had issues printing this when the two pieces were not placed on the bed in the exactly the same orientation. (The honeycomb infill would ‘move around’ to get a best fit). In that case my support rods would not align perpendicular. To fix that I designed in three 1/8" holes that would print the exact same place no matter how they were placed on the be or which infill was chosen.
Also, when printing, pay attention to which side will be on the outside (showing face). Use the raw printed side as the bed side slightly mushes the sharp edges of the honeycomb. I also bumped the infill to 15% (ascetics) with the 3 shells. I've tried printing cross supports and using various plastic rods only to keep returning to the steel rod. Quick spray paint and it's ready to go and is much more secure than any other cross support I've tried. YMMV.
(Ooooh, don't forget the rubber feet!!!)
Yet another remix. This one is to address some concerns from some who's laptops had "soft middles". The extended arm lengthens the contact point and spreads out any stresses on the bottom of the laptop. I could have also reduced the front toe opening but that would have restricted which laptops could use the stand.
Quick note, if these look "thinner" than the others it's not you. Exact same dimensions of the previous prints but only 1/2 as much PLA left on the spool!
Next up on the remix train I'll be adding an "in-foot" to help with some stability for those that don't want to use cross bars.
Like my design, how about a cup of coffee?
