1/35 scale two color traffic cone
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small cone for the small RC cars :) I made this design to be easily printable on an fdm machine, no support needed.…
- Ocena
- 5 / 5
- Polubienia
- 19
- Pobrania
- 113
- Wydruki
- 1
- Wyświetlenia
- 744
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
A small cone for the small RC cars :) I made this design to be easily printable on an fdm machine, no support needed. there is a 0.2mm tolerance between the shaft and the "rings".
I made this because i was unable to find a good two color cone for my micro cars.
My suggestion is to print it with 0.1mm layer height for the best result. Print the base, ring2 and ring4 with color1, and print ring1 and ring3 with color2. In my case, color1 is orange, and color2 is white.
If you don't want to mess with the small rings and stuff, there is a solid, single color version also included. Any suggestions are welcome. :)
Category: R/C Vehicles