PNV-10T Bayonet Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I took inspiration on Orangespy's mount for a PNV-10T to a western Style bayonet mount. I remade the design to fit in…
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 78
- Wydruki
- 0
- Wyświetlenia
- 1425
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
I took inspiration on Orangespy's mount for a PNV-10T to a western Style bayonet mount.
I remade the design to fit in the rail of my 2020 produced PNV-10T and to connect to my Rhino 2 via the 4 screws that come with its bayonet adapter.
It simply slides into the rail and is secured with a M6 Bolt. You shouldn't need more than 5 mm exposed threads to tighten it down enough to hold it snugly. Im using a longer one with 2 nuts attached so that i can have a good grip on it. The screw should probably not be longer than 22 mm or it would interfere with the Rhino mount.
I've made 2 Variants of this mount, one to mount to the front of the Sliding piece and one to mount on the back of it.
You definetely need supports for the piece that slides into the rail of the PNV-10T.
I would advise against printing it standing up, on the one hand, i think the threads wouldn't come out working and on the other hand i would be worried that it could break on the layer lines.
Print Settings
Printer Brand:
Creality
Printer:
Ender 5
Rafts:
No
Supports:
Yes
Filament: Esun PLA+ Post-Printing =============
After printing, you should probably sand the part that interfaces with the PNV-10T to make it slide more freely
Category: Sport & Outdoors