Wardrobe / Cabinet Door Support - Prevents Door Sagging
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This little helper keeps your cabinet door aligned and prevents sagging over time.
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 13
- Wydruki
- 0
- Wyświetlenia
- 229
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
About this project
I built a TV set wall with IKEA cabinets with long (80cm) doors held by only two hinges. The momentum put on those hinges makes the doors sag over time. Additionally, my kids are not always careful operating those doors putting additional weight on them.
To prevent wear and tear of the hinges while the doors are closed, I made those simple helpers that one can easily attach to the doors with two-sided tape.
The doors can then rest on those helpers, removing some stress from the hinges. So the doors always look perfectly aligned when closed.
They have a wedge shape at the front that guides the doors into position even if they sag a bit.
Print Settings
I've printed the clip (twelve in total) using zero infill, zero top and bottom layers but four perimeters. Although I used an e3d Revo 0.8mm nozzle, you should be able to achieve similar results with smaller nozzles. Increase the perimeter count if needed and print the helpers with 0.2mm layer height or whatever floats your boat.
- Permimeters: 4
- Infill: 0
- Top Layers: 0
- Bottom Layers: 0
- Material: PETG
- Nozzle: 0.8mm
- Layer Height: 0.5mm
Support
If you like to support me and my work, please consider following me on:
If you like to buy me a coffee to stay productive and creative, you can do so by sending a tip via Prusaprinters.org or PayPal:
Or feel free to use one of the following affiliate links below (without additional or hidden costs!).
Generic Affiliate Links
Thank you very much, and happy printing,
Martin