1 / 2
LHS CR Touch Mount for S1 with Silent Fans modification — zdjęcie 1
1 / 2

LHS CR Touch Mount for S1 with Silent Fans modification

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

X Offset=-30, Y Offset=0. Probe moved when Hotend Fan is on RHS from mod in https://www.youtube.com/watch?v=TrO5Q0-KEFE

Ocena
0 / 5
Polubienia
19
Pobrania
57
Wydruki
0
Wyświetlenia
1382
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

Required:

  • 2 x M2.5 x 3H x 3.5W knurled nuts for Ribbon Bracket

  • 2 x M2 x 3H x 3.5W knurled nuts for CR Touch. (originally M3 but not enough room for them).

I make use of the 5015 cooling and 4020 Noctua modifications in:

The above youtube modifications have a range of stl prints for 4020, 4015, and various other fan options for the hotend cooler fan to be moved to the RHS. It drastically improves hotend cooling fan.

That modification left a large gap on the LHS, when using the original model I had remixed this from. Hence, I made this remixed version to move the probe even closer. I utilized the gap and reduce the X-offset further. I managed to reduce it down to a 33mm or 30mm option.

The 33mm offset version leaves about 3.2mm gap from the heating block cooling heatsink thus. If you are more comfortable, then the 30mm offset (which leaves about 0.2 gap to the heatsink) is also available.

I've opted for these options because I've found it increasingly easier to get consistent bed leveling, meshes, and z-offsets when the CR-Touch is closer to the hotend.

Please note that knurl nuts are used and soldered in. M2.5 knurl nuts for the Ribbon bracket and M2 for the CR Touch. I have chosen the M2 to allow for small adjustments for the Y-axis.

I recommend printing with PETG or any more heat-resistant material to prevent heat warping.
The one in the image was printed on Klipper firmware S1 Pro. Be careful with the RIbbon  Support Bracket and not overtighten or else it can crack it.

The example pictured is the 33mm offset option printed at 0.2mm height, 0.4mm nozzle. It was tight to fit the 4x M3 bolts holding the extruder into the gantry carriage.
I believe if the model was printed in 0.16mm height, the fit would be less tight or printed with “Slice Tolerance = Exclusive” under Ultimaker Cura.

Edit 29/10/2026: Added the 5015 and 4020 shoud that I used. Mostly so I can come back for it when I need to reprint this.

Tagi