Cup & Bag hook for Knee Rover Scooter
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a bag hook for attachment to the handle bars of a knee rover scooter. Sizing is not exact, but close enough.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 92
- Wydruki
- 0
- Wyświetlenia
- 736
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Home Medical Tools
- Licencja
- Creative Commons — Public Domain
This is probably the most American concept ever, but the knee rover scooter charges extra for a large basket. I was looking for something with a much smaller profile. There are 2 versions of this model- one with a front and back section, the other with 2 sections combined.
Additional parts needed:
- m5 screws 35mm length *4 ( only 2 if you use the combined part)
- m5 nuts *4 ( only 2 if using combined bracket)
The 2 part version of the bracket uses 5mm screws to attach them to each other on the handlebars. Wingnut screws are good if you can find them, as they'd allow hand tightening whenever needed.
Print bracket sections according to the orientation provided for maximum strength.
Cup is meant to be detachable in case it needs to be removed so spills can be dumped out. Spills are also the reason for the hole in the bottom of the cup.
Print in photo is a combination of filaments as they ran out mid-print. Silk is NOT a requirement for this.
- filaments.ca transparent PLA
- mika3d silk bronze
- mika3d silk gold